Adhesive Siser Easy PSV Starling – Dark Beige

Description

Size : 30cm x 1mAdhesive

Surface Prep Instructions
For best adhesion, remove any dirt, dust, grease, etc to prepare the surface you want to decorate with EasyPSV Starling. The
following cleaning method is not recommended for porous surfaces such as unfinished/untreated wood. It is recommended that
all other surfaces be spot tested with care before cleaning the entire application area.
Non-porous surfaces can be cleaned with a mix of approximately 2 parts water and 1 part isopropyl alcohol (70% or higher for best
results) or non-ammonia based window cleaner. Use a microfiber or lint free towel to clean the application area with the mixture.
Paper towel is not recommended since it will leave behind small bits of paper that can become trapped under the EasyPSV during
application. Ensure the area is completely dry before applying.

Application Instructions
1. Place EasyPSV Starling with the liner side down and cut your design. (DO NOT reverse/mirror your design.)
2. Weed excess vinyl.
3. Remove the application tape’s paper liner. Place tape on top of EasyPSV Starling and burnish with a squeegee.
4. Lift the application tape and EasyPSV Starling away from the paper liner to expose the removable adhesive.
5. Place the application tape on your desired object and burnish with a squeegee to fully adhere the design.
6. Gently peel away the application tape, leaving just your EasyPSV Starling design on the object.
Removal Instructions
If the EasyPSV Starling peels up, but leaves an adhesive residue use an adhesive remover to clean the area.
If the EasyPSV Starling is stubbornly sticking, the heat from a hair dryer or garment steamer can help loosen the adhesive.
However, heating is not recommended for glass due to possible shattering. To remove Permanent EasyPSV Starling from glass,
saturate the decal with soap and water. Cover with plastic wrap and let sit for a few hours before attempting to remove.
An adhesive remover may still be required to clean all adhesive from the surface after removing the EasyPSV Starling.

Storage Instructions
For best results, avoid direct sunlight and extreme temperatures. Ideally, temperatures should not surpass 70° F and 50% relative
humidity. When stored properly, EasyPSV Starling has a shelf life of up to 2 years (when stored at the following
temperatures and humidity conditions 68°-77° F (20° – 25° C) and 50±5% relative humidity).

*The cleaning method outlined above is subject to modification and not always suitable for every substrate.
The purchaser should independently determine with their own testing to use this method or not on a case by case basis.
*Permanent adhesive may harm drywall or other painted surfaces.
*Not recommended for use near flame/ heat source, or with microwave.
*The removal instructions outlined above are subject to modification and not always suitable for every substrate.
The purchaser should independently determine with their own testing to use this method or not on a case by case basis